Installing new battery

As I removed the old battery and resistor R91 in advance, I'll cut directly to the installation...
When installing the new battery I used OldCrows procedure.
The following parts where needed for this step:

• 1N4148 diode
• CR-2032 battery
• batteryholder for CR-2032 (max 20mm)

First I had to remove the KLM-367 board from the synth.

The batteryholder didn't fit the soldering holes, so I had to extend and bend the legs on the

holder.
The 1N4148 diode is also seen on the picture, right next to the batteryholder.







I used some hot glue to secure the holder.


Now I just had to pop in the new CR-2032 and the job was done.